750cc FIC Toyota Supra 7MGTE Fuel Injector Clinic Injector Set (Low-Z)

  • Availability: In Stock
  • Product Code: IS146-0750
  • Product viewed: 8535

  • $489.00

Available Options
Toyota Supra Turbo (7MGTE) Fuel Injector Clinic Injector Set to fit OEM Fuel Rail: 6x750cc Peak & Hold / Low Impedance Disc Injectors. Includes pigtails PGTJETR6 or add Plug & Play adaptors PADPJtoD6.

Fuel Injector Clinic's high performance fuel injector sets are precisely flow matched to within 1%. Each injector within each set is individually numbered and results for each injector are listed on a detailed flow sheet included with the set.

Fuel Injector Clinic's high performance fuel injectors are flow tested and rated at 43.5psi (3Bar) at 90 degrees F fuel temperature using CF-16B calibration fluid.

Superior short pulse width control and tight manufacturing tolerances make these injectors easy to tune and provide great drivability.

Fuel Injector Clinic injectors are set up to and include all o-rings needed to fit the factory application for the listed vehicle. For aftermarket or other unusual setups please contact us prior to placing your order to make sure you receive injectors that fit properly.

Every injector is covered against failure caused by defects in original manufacture by our lifetime warranty.

This injector set contains low impedance injectors matched to your factory fuel injector control system which may include an injector resistor pack working in conjunction with your OEM ECU. These injectors are also suitable for use with an aftermarket ECU made or set up for low impedance injectors driven by a peak and hold signal or by a saturated signal together with a resistor pack.

This set of injectors requires you to change the injector plug on the wiring harness in your car. This can be done by soldering in the pigtails (included with purchase) to replace the plugs currently on your harness, or you can choose to purchase the optional plug-n-play adaptors which will convert from the type of plugs on these injectors to the plugs on your harness without any need for cutting or soldering.

This plug conversion is made necessary because FIC always chooses to provide brand new, unused injectors for its performance applications. We do not believe that increasing the chance of a failure due to using remanufactured or core program based injectors is ever warranted.

Fitment Specifications
Bottom O-ring Outer Diameter 16mm Square Seal
Cylinder Quantity 6
Height 64mm
Impedance Low-Z
Plug and Play Adaptor PADPJtoD6
Top O-ring 11mm
Horsepower supported
Engine Aspiration turbocharged
Fuel Pressure 43.5
WHP on E85 at 43psi 90%DC NA 504.40
WHP on E85 at 43psi 90%DC Supercharged 458.54
WHP on E85 at 43psi 90%DC Turbo 420.33
WHP on E85 at 58psi 90%DC NA 582.58
WHP on E85 at 58psi 90%DC Supercharged 529.62
WHP on E85 at 58psi 90%DC Turbo 485.48
WHP on Gas at 43psi 90%DC NA 655.71
WHP on Gas at 43psi 90%DC Supercharged 596.10
WHP on Gas at 43psi 90%DC Turbo 546.43
WHP on Gas at 58psi 90%DC NA 757.35
WHP on Gas at 58psi 90%DC Supercharged 688.50
WHP on Gas at 58psi 90%DC Turbo 631.13

Write a review

Note: HTML is not translated!
    Bad           Good